JVC 48" rear projection TV.

[Dani]

Model # AV-48WP30, it was picked by another shop, & the large stand up
module (tin can type), that one of the plugs from the little
convergence board goes to, has been out of the set,
& put back with no screws, & MAY be bad, even though they don't
commonly go. It had bad convergence. I replaced the stk 392-110
convergence IC's, & resistors. It convergences good, but the overall
pix is shaped wrong, like bad pincushioning. Going from left to right
the scan is up & down, both on top & bottom. I can adjust all service
menu adjustments, but can't get it square. .Anyone see this problem?
Dani.

 

[Art]

Basically have to reset the geometry, aka pcc, heighth, width, etc and then
do all the registration. Can be a bit fustrating and time consuming. There
are other adjustments that yu will need to make and/or repair the pcc
circuits also.
"Dani" <greeben@gmail.com> wrote in message
news:f3522563-7d2c-4164-a258-cbfbea15ffdc@s12g2000prg.googlegroups.com...

Model # AV-48WP30, it was picked by another shop, & the large stand up
module (tin can type), that one of the plugs from the little
convergence board goes to, has been out of the set,
& put back with no screws, & MAY be bad, even though they don't
commonly go. It had bad convergence. I replaced the stk 392-110
convergence IC's, & resistors. It convergences good, but the overall
pix is shaped wrong, like bad pincushioning. Going from left to right
the scan is up & down, both on top & bottom. I can adjust all service
menu adjustments, but can't get it square. .Anyone see this problem?
Dani.