IEEE 1394 Interface

N

NulModem

Guest
Hi all,

I'm looking for a FireWire card I want to plug into an ATA connector on
an embedded board without PCI bus.

I want to reduce the size of the box by replacing the internal hard
drive with a firewire interface card.

Is it possible ?

I know that there's a lot of firewire to ata bridges on the wild but I
made a test with one of them without success.

I undoubtedly made some mistake, especially that I'm not sure it's
possible to reverse the bridge use.

Thanks in advance,
--
Philippe
 
"NulModem" <NulModem@hayes.com> wrote in message
news:1gml649.1yfseat1k9fzvvN%NulModem@hayes.com...
Hi all,

I'm looking for a FireWire card I want to plug into an ATA connector on
an embedded board without PCI bus.

I want to reduce the size of the box by replacing the internal hard
drive with a firewire interface card.
Click to expand...
Perhaps you could mount a 2.5" drive (or smaller) in the space where you
plan to fit the ATA card?
 
Sure, but another requirement is to connect sometimes external drives to
the board.


CWatters <colin.watters@pandoraBOX.be> wrote:

"NulModem" <NulModem@hayes.com> wrote in message
news:1gml649.1yfseat1k9fzvvN%NulModem@hayes.com...
Hi all,

I'm looking for a FireWire card I want to plug into an ATA connector on
an embedded board without PCI bus.

I want to reduce the size of the box by replacing the internal hard
drive with a firewire interface card.

Perhaps you could mount a 2.5" drive (or smaller) in the space where you
plan to fit the ATA card?
Click to expand...
 
You must log in or register to reply here.

Welcome to EDABoard.com

Sponsor

Back
Top