Bridge BM14L Monitor with burned resistors

[Roy]

I have a defective Bridge BM14L Monitor. I opened the case and upon
close inspection found two burned resistors, namely: R332 and R340. I
want to replace them both but I dont know the values and I dont have
the schematics or manual. What should I do? Thanks for any help or
info.

 

[Tom MacIntyre]

On Sun, 03 Aug 2003 03:37:46 GMT, Tom MacIntyre
<tom__macintyre@hotmail.com> wrote:

On Sun, 03 Aug 2003 03:20:09 GMT, Tom MacIntyre
tom__macintyre@hotmail.com> wrote:

On 2 Aug 2003 19:32:42 -0700, limraul@yahoo.com (Roy) wrote:

I have a defective Bridge BM14L Monitor. I opened the case and upon
close inspection found two burned resistors, namely: R332 and R340. I
want to replace them both but I dont know the values and I dont have
the schematics or manual. What should I do? Thanks for any help or
info.

The resistors have likely burned due to one or more components. Find
the faulty component(s) first, or be prepared to waste a few
resistors, or possibly doing more damage.

Oops...ome or more components drawing too much current. Sheesh.

Tom

It is time for bed when one follows a mistake with yet another in the
correction...

Tom

You may be able to get at least ballpark values for these resistors by
scraping each resistor down, and measuring the resistance on either
side of where they opened, then adding up the total. This doesn't
always work.

Tom