very basic question

Phil Allison wrote:
"aussiblu"

PS and yes I didn't notice until you pointed it out. It is
actually very hard to find a correct and clear IEC plug and
socket wiring guide on the net.

** If you find one - post it.

....... Phil
Click to expand...
<http://www.switchcraft.com/products/pdf_files/connector-55b_schematic.pdf>
--
Service to my country? Been there, Done that, and I've got my DD214 to
prove it.
Member of DAV #85.

Michael A. Terrell
Central Florida
 
I was asking was it wrong in what it describes as a socket.

--
Regards
Blue

Remove ZX from email address to reply directly.
 
Can't see any 'pinouts' given there just dimensions.

--
Regards
Blue

Remove ZX from email address to reply directly.
 
aussiblu wrote:
Can't see any 'pinouts' given there just dimensions.
Click to expand...

Then you didn't look very close. 'L", 'N', and 'E' are shown,
exactly where Switchcraft molds it into their products. It is visible
on their EAC227, EAC327, EAC309,EAC315, and EAC311 drawings.


--
Service to my country? Been there, Done that, and I've got my DD214 to
prove it.
Member of DAV #85.

Michael A. Terrell
Central Florida
 
Sorry; aging eyes after blowing them up to 200% I can see them.

--
Regards
Blue

Remove ZX from email address to reply directly.
 
aussiblu wrote:
Sorry; aging eyes after blowing them up to 200% I can see them.
Click to expand...

200%? Hell, that's where I *start*, and I use a 22 inch monitor. ;-)


--
Service to my country? Been there, Done that, and I've got my DD214 to
prove it.
Member of DAV #85.

Michael A. Terrell
Central Florida
 
You must log in or register to reply here.

Welcome to EDABoard.com

Sponsor

Back
Top