ADE XL Sweep Issue...

K

kngor

Guest
Hi everyone,

I am trying to use ADE XL to perform a parametric sweep of some parameters.
If I only input 1 set of parameter values, the test runs fine and there are no issues.
Once I add another value to sweep in the parameter (i.e. Voltage = 1,2) then ADE XL is stuck in pending.
No job log is created and it will stay in pending until it timeouts.

Any ideas?

Thanks!
 
Try spacing instead of comma, i.e. 1 2
Hope it work
On Sunday, September 27, 2020 at 9:14:24 AM UTC+2, kngor wrote:
Hi everyone,

I am trying to use ADE XL to perform a parametric sweep of some parameters.
If I only input 1 set of parameter values, the test runs fine and there are no issues.
Once I add another value to sweep in the parameter (i.e. Voltage = 1,2) then ADE XL is stuck in pending.
No job log is created and it will stay in pending until it timeouts.

Any ideas?

Thanks!
 

Welcome to EDABoard.com

Sponsor

Back
Top