buddy
Guest
Mon Jan 02, 2012 11:35 pm
I need to change the drive belt on the vcr it looks like I would have to
pull the whole board out to get underneath the transport ,does this sound
right or is there a better why of doing it,older vcr's you could take the
transport out model number is Sylvania dvc-845 E any help?
thanks
b
Guest
Sat Jan 07, 2012 1:25 pm
On Jan 2, 11:35 pm, "buddy" <buddy...@hotmail.com> wrote:
Quote:
I need to change the drive belt on the vcr it looks like I would have to
pull the whole board out to get underneath the transport ,does this sound
right or is there a better why of doing it,older vcr's you could take the
transport out model number is Sylvania dvc-845 E any help?
thanks
In most the later centre-transport vcrs, you first have to remove the
connectors to the heads then unscrew and remove the deck , then unclip
and remove the pcb. It's not as bad as it sounds, tends to take under
10 mins.
-B
buddy
Guest
Sat Jan 07, 2012 9:57 pm
"b" <reverend_rogers_at_yahoo.com> wrote in message
news:51736d5e-ebaa-44fb-ba72-46f2b40bc457_at_a40g2000vbu.googlegroups.com...
On Jan 2, 11:35 pm, "buddy" <buddy...@hotmail.com> wrote:
Quote:
I need to change the drive belt on the vcr it looks like I would have to
pull the whole board out to get underneath the transport ,does this sound
right or is there a better why of doing it,older vcr's you could take the
transport out model number is Sylvania dvc-845 E any help?
thanks
In most the later centre-transport vcrs, you first have to remove the
connectors to the heads then unscrew and remove the deck , then unclip
and remove the pcb. It's not as bad as it sounds, tends to take under
10 mins.
-B
Ok thank you finished it up today I had to take dvd rom out pull the one
piece main board then 2 screws holding the transport to the board just to
get to the belt ..older ones were easier lol I can't wait for spring
fishing thanks again
