nospam
Guest
Sun Aug 08, 2010 9:11 pm
I am designing a small PCB (about 15 x 60mm) which will have an M3 mounting
hole each end. I need to fasten a cable (probably 3-4mm diameter) to the
board and a small P clip under one of the mounting screws seems like a good
plan.
I have some p-clips in my junk box which are about the right size, about
14mm long and 6.5mm wide and would take a 5mm cable. The only marking on
them is "NXI".
I can't seem to find a source for anything this small. They all seem to be
9.5mm wide and even the ones taking a 3.2mm cable are about 18mm long.
Can anyone point me at a supplier or catalogue with a good range of small
p-clips?
Spehro Pefhany
Guest
Mon Aug 09, 2010 12:58 am
On Sun, 08 Aug 2010 21:11:56 +0100, the renowned nospam
<nospam_at_please.invalid> wrote:
Quote:
I am designing a small PCB (about 15 x 60mm) which will have an M3 mounting
hole each end. I need to fasten a cable (probably 3-4mm diameter) to the
board and a small P clip under one of the mounting screws seems like a good
plan.
I have some p-clips in my junk box which are about the right size, about
14mm long and 6.5mm wide and would take a 5mm cable. The only marking on
them is "NXI".
I can't seem to find a source for anything this small. They all seem to be
9.5mm wide and even the ones taking a 3.2mm cable are about 18mm long.
Can anyone point me at a supplier or catalogue with a good range of small
p-clips?
http://www.mouser.com/catalog/specsheets/EPD-200464.pdf
Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
speff_at_interlog.com Info for manufacturers:
http://www.trexon.com
Embedded software/hardware/analog Info for designers:
http://www.speff.com
nospam
Guest
Mon Aug 09, 2010 3:42 am
Spehro Pefhany <speffSNIP_at_interlogDOTyou.knowwhat> wrote:
Quote:
Thanks, smaller than anything I found. Maybe I should be searching for
cable clamps.
