pmi
Guest
Thu Aug 11, 2011 1:21 am
I have a 1989 maytag series 1000 stackable. The dyer finally stopped
heating up. I was told by a repairman that I needed a new heating
element. Had it replaced and also had machine and all the vents
cleaned, which had not been done for a very long time. Since the
repair, periodically and sometimes every day the 7E error shows up on
the led panel. This never happened before iin the 17 years I have
used this dryer only after the new heating element was put in. I also
replaced the two circuit breakers for the machines. When the 7E
appears I reset the breakers and can run the dryer again for the rest
of its cycle.
I have also noticed that since the heating element was replaced the
clothes are frequently extremely hot when I take them out of the
dryer.
I would appreciate any suggestions.
Thanks so much.
Guest
Thu Aug 11, 2011 1:29 pm
On Wed, 10 Aug 2011 16:21:07 -0700 (PDT), pmi <pmicsw_at_aol.com> wrote:
Quote:
I have a 1989 maytag series 1000 stackable. The dyer finally stopped
heating up. I was told by a repairman that I needed a new heating
element. Had it replaced and also had machine and all the vents
cleaned, which had not been done for a very long time. Since the
repair, periodically and sometimes every day the 7E error shows up on
the led panel. This never happened before iin the 17 years I have
used this dryer only after the new heating element was put in. I also
replaced the two circuit breakers for the machines. When the 7E
appears I reset the breakers and can run the dryer again for the rest
of its cycle.
I have also noticed that since the heating element was replaced the
clothes are frequently extremely hot when I take them out of the
dryer.
I would appreciate any suggestions.
Thanks so much.
If the breaker never tripped before, I would suspect an incorrect
element or incorrect wiring of the element.
John
John Fields
Guest
Fri Aug 12, 2011 12:45 pm
On Wed, 10 Aug 2011 16:21:07 -0700 (PDT), pmi <pmicsw_at_aol.com> wrote:
Quote:
I have a 1989 maytag series 1000 stackable. The dyer finally stopped
heating up. I was told by a repairman that I needed a new heating
element. Had it replaced and also had machine and all the vents
cleaned, which had not been done for a very long time. Since the
repair, periodically and sometimes every day the 7E error shows up on
the led panel. This never happened before iin the 17 years I have
used this dryer only after the new heating element was put in. I also
replaced the two circuit breakers for the machines. When the 7E
appears I reset the breakers and can run the dryer again for the rest
of its cycle.
I have also noticed that since the heating element was replaced the
clothes are frequently extremely hot when I take them out of the
dryer.
I would appreciate any suggestions.
Thanks so much.
---
Just a guess, but I'd suspect a defective thermostat or whatever's
being used to control the element's temperature, or maybe a slow
blower.
In any case if the repair is still under warranty I'd call the company
and let them know about the problem.
Then, there's also:
https://www.maytag.com/webapp/wcs/stores/servlet/OCManualsLiteratureSearchView?catalogId=10562&langId=-1&storeId=10212&krypto=5QgxQhneFliXuEuX564wSQ%3D%3D&ddkey=http:OCManualsLiteratureSearchView
--
JF
