Altera Flex10K support ?

Wed Aug 17, 2011 7:07 pm   

Hi
I have found old parts lying around in the lab and I could put them to
good use. Alas, they are not supported by Quartus any more. Do you know
which version of the tool I should get (and where I could get it, if
Altera doesn't provide it) ?

Thanks
Nicolas

Wed Aug 17, 2011 7:18 pm   

"Nicolas Matringe" <nicolas.matringe_at_fre.fre> wrote in message
news:4e4c1188$0$7330$426a74cc_at_news.free.fr...


Quartus V9.1 sp2 (the last sensible version before the excellent internal
simulator was dropped) supports Flex10k.

Should still be available on Altera website.

Phil

Wed Aug 17, 2011 7:27 pm   

Le 17/08/2011 21:18, Phil Emmup a écrit :



Thanks a lot.
I finally found the old version page on Altera website.

Nicolas

Thu Aug 18, 2011 4:14 pm   

On Aug 17, 2:27 pm, Nicolas Matringe <nicolas.matri...@fre.fre> wrote:

Note, Altera often supports parts long after they stop showing up in
the device selection panel. I have a board with somewhat rare
Flex10K100 on it (specifically, a 10K100GC503-3), that quit showing up
in the drop downs a very long time ago. The original design was done
in MaxPlusII!

I have to manually edit the QSF with the specific part number to get
it to work. However, if you get the part number exactly right, Quartus
will set everything else up for you. Even the pin mapper works
correctly.

It's as if Altera doesn't want to advertise support for these older
parts, but keeps it anyway. This may not apply to the Flex10K for
current versions, but as a general rule, Altera (and Xilinx) often
support obsolete parts this way.

Mon Aug 22, 2011 8:29 am   

On 17 août, 21:18, "Phil Emmup" <ph...@hotnots.rot> wrote:

Hi
It was actually V9.0, as stated in this 9.1 note
http://www.altera.com/literature/rn/rn_qts_91sp2_dev_support.pdf

Nicolas

Mon Aug 22, 2011 8:32 am   

On 18 août, 16:14, radarman <jsham...@gmail.com> wrote:

The thing is that since I'll be working on a new design (and I haven't
used these parts for years, and I changed company since) I don't have
any QSF example. I'll work with Quartus v9.0 at first and see if I can
migrate the design to a more recent version.



Maybe they don't want too much advertising to avoid getting requests
for the parts they don't supply anymore.

Thanks for the tip
Nicolas